Skip to main content
Commander with Fortinet router
Written by Kashif Matin
Updated over a week ago

STEP 1: Locate the Fortinet Router connected to your Commander POS (pictures below, models may vary):

  • STEP 2: Connect the Ethernet cable from the Back-Office Computer to any 'open' and available port on Fortinet Router.

STEP 3: Log into your Windows Operating System with Administrative rights. Open Control Panel, Network & Sharing Center -> Change adapter options -> Right click on your Ethernet Card or Ethernet-usb-adapter connected to the Mako router. Locate -> Internet Protocol Version 4 (TCP/IPv4) and enter the IP settings below:

  • Setup the I.P. on the connection as Follows

  • I.P. address

  • Subnet Mask

  • Default gateway

STEP 4: Open a internet browser such as Google Chrome (recommended) or Firefox:

  • Connect to C-store Petroleum site using the URL listed below:

STEP 5: If unable to access Petroleum Control Center (shown above) then please contact Fortinet router Support. Explain them you are installing a new back Office and would like a PORT opened and IP address Mapped to Reach the Petroleum site.

STEP 6: Repeat Steps 1-4.

Did this answer your question?