STEP 1: Locate the V1 CYBERA ROUTER connected to your PASSPORT POS (Models may vary)
STEP 2: Connect the Ethernet cable Form the Back-Office Computer to PORT 2 On Cybera Router.
Step 1: On your Back Office PC, go to Control Panel > Network and Internet > Network and Sharing Center > Click on Change Adapter Settings [?]
Step 2: Right-click on the Ethernet Adapter network and click on properties [?]
Note: In the Adapter Settings screen, there are a list of networks, you should see your Ethernet Adapter plugged in
Step 3: On the Properties window, select option Internet Protocol Version 4(TCP/IPv4) and click on properties.
Step 4: On the new Properties window select the option labeled as "Use the following IP address", and type the following information.
I.P. address 10.96.10.2
Subnet Mask 255.255.255.0
Default gateway 10.96.10.1
Preferred DNS 8.8.8.8
Alternate DNS 8.8.4.4
Once connection is established, map the network drive on your computer to start receiving and share files with the Passport POS. Click on Windows Start Button > Computer > right-click on Network option on the left side of the new window and select "Map Network Drive"
Step 7: On the "Map Network Drive" window enter the following:
Select the Drive as Z (if Z is taken, any other letter will work)
Enter the path name under the folder option: \\10.5.48.2\XMLGateway
Depending on the port you put on Cybera Router, The last Digit of I.P. Address changes. Any port will work.
If it is on port 1 & 2 put 10.96.10.2
If it is on Port 3 put 10.96.10.3
If it is on port 4 put 10.96.10.4
Note***When using a Cybera router, a single ethernet cable will provide access to both Internet and XML folder.
Or if they are running on 2 network cables use this command on CMD or PowerShell.
(Use route -P add 10.5.48.0 mask 255.255.255.192 10.96.10.1 metric 1)
